「锥型旗杆」不锈钢旗杆预埋深度说明 -旗杆,不锈钢旗杆「中国旗杆网」

四川11选5

公司承诺:
生产最好的旗杆,做最完美的旗杆工程
全国服务热线:联系我们  
东北旗杆网   
  • 联系电话:13940183063
  •   
  • 固定电话:024-31081023
  •   
  • 联系人:于经理
  •   
  • 全国客服:4006-080-090
  • 您现在的位置是   四川11选5>>最新资讯 >> 「锥型旗杆」不锈钢旗杆预埋深度说明

      「锥型旗杆」不锈钢旗杆预埋深度说明

      作者:沈阳锥型旗杆厂家   时间:2019/7/8 14:00:42

    • 「锥型旗杆」不锈钢旗杆预埋深度说明



      What is the embedding depth of the "conical flagpole" 12 m high flagpole




      不同高度的旗杆对应着不同的预埋深度和底板厚度,因为越高的沈阳旗杆需要更稳定的底座,因此预埋深度增加,底板厚度、孔距和混凝土基础都随之增加。


      The flagpole of different height corresponds to different embedded depth and floor thickness, because the higher the flagpole of Shenyang needs a more stable base, so the embedded depth increases, and the floor thickness, hole spacing and concrete foundation increase accordingly.


      比较高的旗杆,在安装的时候需要特别注意底部固定,因此旗杆底部预埋固定就变得非常重要。


      For the high flagpole, special attention should be paid to the bottom fixing when installing, so the pre-embedded fixing at the bottom of the flagpole becomes very important.

       

      沈阳不锈钢旗杆厂家



      「锥型旗杆」12米高旗杆预埋深度是多少


      What is the embedding depth of the "conical flagpole" 12 m high flagpole



      不锈钢锥形旗杆需先预埋预埋件,预埋件坑挖1*1*1M,天气晴好情况下,一般约7天时间,预埋混泥土凝固,即可安装旗杆。


      The stainless steel conical flagpole needs to be pre-embedded, and the pre-embedded parts are excavated 1 * 1 * 1M. When the weather is fine, the pre-embedded concrete solidifies in about 7 days, and the flagpole can be installed.


      一般三根12米高度的预埋坑的高度为0.8米到1.5米之间,两根之间的旗杆间距1.5-1.8米,旗台长度4.2-5米。也可根据客户的要求做适当调整。


      Generally, the height of three 12-meter-high pre-buried pits ranges from 0.8 m to 1.5 m. The spacing between the two flagpoles is 1.5-1.8 m, and the length of flagpole is 4.2-5 M. It can also be adjusted appropriately according to the requirements of customers.


      预埋件由标准地脚螺栓及角铁或钢筋焊接而成,依据旗杆高度的不同来配比地角螺栓的尺寸,高度越高,地脚螺栓尺寸越大。


      四川11选5 Embedded parts are welded by standard anchor bolts and angle iron or steel bar. The size of anchor bolts is proportional to the height of flagpole. The higher the height, the larger the size of anchor bolts.

       

      沈阳不锈钢旗杆价格




      旗杆预埋件预埋后,待到混泥土干后,用吊车把旗杆竖直起来,焊在旗杆底部的法兰四个螺孔对准四根地脚螺栓套下,旗上垫片,弹簧片,旋上螺帽,旗杆即可固定住,最后从多个角度来调整旗杆的垂直度。


      After pre-embedding the flagpole, when the concrete is dry, the flagpole is erected with a crane. Four bolt holes of the flange welded at the bottom of the flagpole are aligned with four anchor bolts. The flagpole can be fixed by gaskets, spring sheets and screwing nuts. Finally, the verticality of the flagpole can be adjusted from multiple angles.


      在风大的地区,对于一个高度的旗杆可以提高一个预埋等级。


      In windy areas, for a high flagpole, an embedding grade can be raised.


      因为不锈钢旗杆自身高度很高,如果没有地面下的预埋固定,很难保证旗杆的稳定性。


      Because the height of stainless steel flagpole itself is very high, it is difficult to ensure the stability of flagpole without embedding and fixing under the ground.

       

    四川11选5官网 四川11选5开奖结果 四川11选5 四川11选5走势图 四川11选5走势图 辽宁11选5 四川11选5走势图 辽宁快乐12 四川11选5 四川11选5